To prevent the use of carbide as a sealing material
As the injection molding machine produced carbide reasons mainly have the following 2 points.
• 1, molding machine in the resin retention time is too long.
• 2, resin in the molten state it is exposed to air.
• machine during downtime, although will be cut off the power supply after emptying machine can also be seen, but at this time to fully to reduce temperature, heating up again and want to restore this condition.
In order to prevent carbides from being produced when the machine is stopped, it is effective to seal the screw rod with hard carbonized resin for replacement before the machine is stopped.
• wash plastic treasure X-cleanTM CM - 1001 can be used as sealing material, and opens up a new application scenarios.
X-cleanTM  CM-1001 not only can be retained for a long time, it is not easy to carbonize when in contact with air, but also contains the ingredients to make the carbide plastic soft.
Therefore, when the machine is shut down, it can be soaked in advance.
In addition, the plastic component of carbide is not an interfacial active agent.
In fact, the reason that X-cleanTM  CM-1001 can be used as a sealing material is because it has the properties of hard carbonization and softening carbides!